This is a discussion on Seatbelt bypass within the Electrical forums, part of the Can-Am Commander UTV Garage category; found this link on FB this morning from UTV Weekly....for all of us that want to add seatbelt harnesses...this might be the answer... TurnKey UTV Can-Am Commander Seat Belt Sensor ...
found this link on FB this morning from UTV Weekly....for all of us that want to add seatbelt harnesses...this might be the answer...
TurnKey UTV Can-Am Commander Seat Belt Sensor Delete Kit : UTVWeekly.com
25 Bucks for a jumer wire is a bit extream. Buy a matching plug and make your own or just splice the two wires together.
He who wares out his Toys in the end Wins!
We will bypass ours for sure...
Last edited by Factory UTV; 10-01-2010 at 04:31 PM.
This is the same plug as the hood light connection under the hood of many chevrolet vehicles (88-98 trucks for sure). Go to the junkyard and pick one up, splice the wires together and use some shrink tubing....dunnzo
This will keep you from modding your factory harness and potentially screwing your warranty.
Why not just take the latch off the seat belt and then connect it? Then you could just tuck it down between the seat and the engine compartment where it's not seen.
"Make it idiot proof and someone will make a better idiot."
I used a U type solderless connector. Simple, effective, priceless, almost.
if you take your seat beat apart you will see the switch. You can either remove the spring and tape the lever down or put a small zip tie on it and your good to go
Why can't you get the male end of a seat belt and plug it into the other end won't that do the same thing. Been doing it on vehicle's for a long time.
I agree it can be a pain but...I have been an EMT for the last 5 years and have seen what can happen when people don't wear there seat belt so I think I will get use to wearing mine.
All times are GMT -6. The time now is 02:20 AM.
vBulletin ® Copyright © 2000 - 2014, Jelsoft Enterprises Ltd.
Copyright © 2010-2011 CommanderTalk.com. All rights reserved.