2016 Can Am Commander 800 with only 114 miles on it cranks but has no spark. Battery is fine, both plugs are fine, and coil is receiving power.

So, my low mileage 2016 Can-Am Commander 800 has no spark. The condition presented itself suddenly after going for a short ride on my property. The ignition fuse is good. The battery is good. The spark plugs are good with 4.2 K ohms of resistance. Both spark plugs were tested in a different vehicle and spark well when placed in the boot with the spark plug against the block. The coil Is receiving power through the middle wire when the ignition switch is turned on. Fuel pump cycles normally at ignition on. I am not sure how to test to see if the coil is getting a ground signal. I was wondering if anyone knows what would be the next step in the testing process. CPS testing/location? Thanks.