Can-Am Commander Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I had a dead battery, so I took it out, charged it,put it back in and tried to start it. The engine would not turn over, just click. I have power, as the center panel lights up. When I put it on lights and start, it clicks and the center screen goes nuts! What have I done wrong? I own a 2012 commander XT.
 

·
Administrator
Joined
·
2,343 Posts
Make sure positive and negative is correct (don't hate, have to make sure it's correct)

Check your + and - cables at the starter and ground for tightness along with at the battery.

Could be a bad cell in the battery. If there is, it wouldn't take a charge properly and will need to be replaced.. have a shop check it for you for accepting charge, then run a load test.



sent by a twin turboed RAZR
 
1 - 3 of 3 Posts
Top