Can-Am Commander Forums banner
1 - 7 of 7 Posts

Premium Member
543 Posts
Discussion Starter · #1 ·
Push pin / Push Clip / Tufloc plastic Rivet / Part# 293150089

Here are the pry tools I use to get the push clips out.
You can find them all over and in different colors. For about $7 to $10 for this set.
I bought 5 sets and use them all the time. I keep one in the Commander glove box. The middle tool in the picture is the one I use 95% of the time.

Here is the link if you want to order these from Harbor freight or Jeggs. Same thing but maybe different color.

$20 from Jeggs
JEGS Composite Non-Mar Pry Bar Set - JEGS

$7 from Harbor Freight.
5 Piece Auto Trim and Molding Tool Set


46 Posts
They should make a 2 stage pry bar like the 2nd one. 1st stage pulls the center up and then the 2nd stage slides under the large part and pulls it all out.
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.