Can-Am Commander Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
After a Shop in Utah added a street legal kit on a ride some wires melted and the rear lights went out, they fixed the wires that fried after their install but the brake lights still did not work, they said it was the brake pressure switch but they did not have the part. I traveled home and ordered the part and replaced the switch but still no brake lights? Suggestions?


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
1 Posts
That's quiet sad to hear. If the flashers aren't working either, check the flashers and the circuit. Otherwise, check the fuses - there could be a separate fuse for the brake lights. If your model is using the same circuit for the turn signals and the brake lights, you need to check the turn signal switch.

Well, anyways, take the vehicle to an expert mechanic. Don’t try to fix anything whether it is a major repair or a small one when you have little knowledge about car mechanism.
 
1 - 2 of 2 Posts
Top