Can-Am Commander Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
After a Shop in Utah added a street legal kit on a ride some wires melted and the rear lights went out, they fixed the wires that fried after their install but the brake lights still did not work, they said it was the brake pressure switch but they did not have the part. I traveled home and ordered the part and replaced the switch but still no brake lights? Suggestions?


Sent from my iPhone using Tapatalk
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top