Can-Am Commander Forums banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
1,424 Posts
Discussion Starter · #1 ·
Anyone happen to know what the gear ratio in the diffs are on the Commander?



 

·
Registered
Joined
·
49 Posts
Lift up the rear end and mark the drive shaft and mark the wheel and count the revolutions of the wheel to the drive shaft or just move it on the ground and divide them and thats your ratio mine was 3.50 -1 3.50 revolutions of the driveshaft to 1 of the wheel.Geez i hope i said that right.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top