Can-Am Commander Forums banner
1 - 2 of 2 Posts

·
Administrator
Joined
·
2,344 Posts
HA guy i am very new to the commander, i need some help on how to get the covers off where the gear shift is so i can insulate it any help would be nice,,e mail [email protected]
Welcome to CT Gordon. Remove 2 screws from top of your center cluster and swing it aside. Remove 1 screw from the console grab handle and pull off rubber. Remove 1 screw from the base of gear shifter. The rest are plastic pull pins to remove the engine top cover, all side panels and both below seat plastics.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top