Can-Am Commander Forums banner

Grab Handles

5110 Views 10 Replies 6 Participants Last post by  dieselpowered
Okay, I have a question if you look at most of the pictures I have seen of the front of the roll cage you will see a built in grab handle. On the production Commander that space where your fingers go through the handle is filled with a steel plate. Do you think I should cut it out so you can use the grab handle? It would be real easy to remove (only a couple of tabs) and I think with a little touch-up paint would make things all good. Cut it out or keep it covered??? [email protected]
1 - 1 of 11 Posts
I Agree with that ...
As do eye....aye.....I (there's the right one):giggle:.....Lance
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.