Can-Am Commander Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I own a 2012 Commander 1000 XT. I started to notice rear diff fluid on the floor and traced it to the bottom side of the driver side rear axle where it's connected to the diff. I pulled the rear diff out and, because of my curiosity, took the 4 screws out to separate the housing in half. I left the pinion gear in and have not pulled any seals out yet. I want to know the proper way to rebuild this diff. Just new seals and wear rings? I'd like to clean it all up inside and out. Do the need the pinion gear nut remover and do I then need new needle bearings?

I just don't like cutting corners so I want to learn the correct way to do this rear diff right. Thanks for any comments/instructions/advice.

Michael
 
1 - 1 of 1 Posts
Top