Can-Am Commander Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Well after sucking muddy water into cvt exhaust. Trans wont shift when engine is running. So I followed LBR old post tore cvt apart and primary 3 of the arms were stuck and the spring cup that butts up to one way was stuck in the outer sheave. Now that its all cleaned up where is a good place to get a new bolt for the primary. I see on the parts fiche its a 12mmx135mm could you just get a grade 8 bolt or should I just get the airdam hardened bolt.
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
Yeah I saw the part and the cost but was looking at the airdam bolt set $30 for primary and secondary. I hate to buy the can am bolt and then have to do it again if I take primary out again. But then I understand airdam is hard to get ahold of and he doesnt show the bolts on his site.
 
1 - 3 of 3 Posts
Top